Page 1 of 1
Model 1300 Gap in Ejection Port Cover
Posted:
Wed Sep 24, 2014 3:01 pm
by topshot
Bought a Winchester Team NWTF Model 1300 Pump Shotgun in the spring at a gun show from a local dealer. Not sure the year it was made either, but I noticed a slight gap in the front and a bigger gap in the back of the ejection port cover. No real issues with it, just wondering if this is in all models of the 1300 or not?
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Sun Dec 07, 2014 8:28 pm
by GUNNER_D
My 1300 has a gap too where the bolt is on a downward tapper if you could post a picture that would be helpful
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Mon Dec 08, 2014 2:25 pm
by SHOOTER13
Welcome to the Winchester Owners Forum topshot !!
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Sat Feb 07, 2015 9:30 am
by topshot
Thanks Shooter13. Also, here are 2 photos. 1 of the front, 1 of the back. Sorry for the late reply.
- gap2.jpg (77.4 KiB) Viewed 7968 times
- gap1.jpg (156.04 KiB) Viewed 7968 times
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Sat Feb 07, 2015 9:31 am
by topshot
Haven't had a problem shooting it what so ever. Seems like it was just made this way.
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Sat Feb 07, 2015 4:30 pm
by SHOOTER13
Not an expert on this model...but if it shoots OK, I wouldn't worry !
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Sun Feb 08, 2015 8:57 am
by topshot
Yeah, I'm not to worried about it but, would still like to know if this is just how the model 1300 is. If not, I just may look into getting it fixed to prevent any future problems. Let me know what you think Gunner_D!
Re: Model 1300 Gap in Ejection Port Cover
Posted:
Mon Feb 09, 2015 1:49 pm
by SHOOTER13
Copy that...let us know what you find out.