New SXP owner, need help
Posted: Sat Dec 12, 2015 3:56 pm
Hello folks, thought I would try get an answer from this forum about my new SXP Extreme Defender. I just got this a couple days ago and was reading the manual today. It recommends disassembling, cleaning and oiling prior to use. The problem is I can't get the trigger group to pull out after I remove that pin. I removed the barrel, cocked the gun and put the safety on just like the manual said. Then removed the pin but the trigger group only lifts up about 1/8" I tried wiggling but no go.
I did clean and oil the mechanism the best I could, cleaned and oiled the barrel and fired a couple shots off without any problems.
Any ideas?
I did clean and oil the mechanism the best I could, cleaned and oiled the barrel and fired a couple shots off without any problems.
Any ideas?