Page 1 of 1
Model 70 7mm WSM- Parts and direction needed
Posted:
Tue Nov 06, 2012 1:13 pmby alabaster
I have a 7mm WSM with a broken stock. It is the cheapy plastic one with the 2 piece trigger guard/ Mag cover. I have the follower and the spring, but need the other parts.
I intend to drop this into a Hogue overmolded stock set for a two-piece lower or a 1 piece depending on parts availability and pricing.
Can you all help me find what I need? I am searching ebay and all to try and keep this from becoming a $400 project. Thanks a million.
Hope you all vote today.
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Wed Nov 07, 2012 2:31 pmby SHOOTER13
Welcome to the Winchester Owners Forum alabaster !!
I'll see what, if anything I can find...
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Mon Nov 26, 2012 2:38 pmby alabaster
MAN!!! I can't believe this... I have NEVER searched for parts like this without finding something. I have looked for some hard to find stuff before too!
I have looked high and low and can't find this stuff ANYWHERE. It's not that old of a rifle and it's a 7mmWSM, so I would've thought I'd see the stuff much quicker than NEVER.
If someone could point me to parts suppliers or something it would be a HUGE help. I've looked at :
Wisners
Brownells
Midway
ebay
natchez
numrich
winchester
GOODNESS GRACIOUS...... Thanks for your help guys.
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Mon Nov 26, 2012 3:01 pmby SHOOTER13
Seems like you looked everywhere I can think of...
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Wed Nov 28, 2012 3:03 pmby alabaster
FOund em on ebay. Had to buy short and long action sets because he was selling 'em as a "4some". $110 approx with shipping.
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Wed Nov 28, 2012 3:48 pmby SHOOTER13
That's great...!!
Re: Model 70 7mm WSM- Parts and direction needed
Posted:
Tue Dec 04, 2012 12:35 pmby alabaster
NOw I have parts......... I understand that the short action is the right one for the 7mmWSM. I have just ordered the extractor, spring, plunger, spring and the ejector, pin, and spring. I can't find the parts diagram fo r this rifle anywhere. Winchester is sending me one so that will help, but I need answers quick.
The receiver, barrel, bolt are all in fine condition. It's the small bits at the bolt face that I need to have. Does this seem like it? I am re-doing the ejector too
Thanks for your attention too, SHOOTER13.
Edit; I have the 2 piece trigger guard and hinged florplate now. I intend to drop this int a Hogue stock. I have the screws(3) from the trigger guard and the hinged short action floorplate. The follower and spring are good and so is the mag box...
Alabaster