WinchesterOwners.com

Been quite a while since I worked on this . Kind of gave up .

Tried to mount a scope on the rifle , with Waver 2 piece mounts , best I recall .

Could not get enough elevation . Can not remember if it needed to go up or down .

I tried shimming the scope , in one of the rings . Got to the point where the shims were too thick for the standard ring " caps " to work . The standard screws ended up being too short .

Best I remember , one of the bases could be turned 180 degrees . Tried that and no joy .

Any helpful ideas ? My eyes are getting too old to do much good with the iron sights .

God bless
Wyr

Welcome to the Winchester Owners Forum !!

Please introduce yourself to our community via the New Member Welcome Area...

Enjoy the forum.

BTW...your reloading question was removed from the M1894 area...

If you want to talk reloading...the Ammunition sub forum is where you should post...

Thanks !

This is the thread I mentioned in my post. I gather that you have no answer, but I am hoping you have folks that frequent this site that could answer the question. As the originator of this thread, without optics, my 94AE is a useless gun safe filler.