Need a butt plate for a 94ae
3 posts
• Page 1 of 1
Copper BB
Posts: 5
Joined: Sat Nov 10, 2012 4:54 pm Location: Marshalls Creek PA |
 Posted: Sat Nov 10, 2012 6:30 pm
Hey im new to the site.. I have a bunch of Winchester in different models but what I am looking for is a factory butt pad for 94ae in 444 that I just picked up. someone put a thick one on and did a crude job, i would like to make it original again.. Anybody have one I could buy or know of any ? i looked on Numrich and ebay .. Thanks
|
zrt1000's Profile
.22LR
Posts: 15
Joined: Thu Nov 08, 2012 5:03 am Location: Bathurst, NSW Australia |
Posted: Sat Nov 10, 2012 10:39 pm
Bubba didn't shorten the stock while he was at it did he?
"I'll helpyou down the trail and proud to!" Rooster Cogburn.
Towns tamed, widders consoled, deep thoughts thunk, sipping whisky graded. |
Copper BB
Posts: 5
Joined: Sat Nov 10, 2012 4:54 pm Location: Marshalls Creek PA |
Posted: Sun Nov 11, 2012 7:08 am
lop is 13.5" so i think I am good there..
|
3 posts
• Page 1 of 1
Return to Winchester Model 1894
Who is online
Users browsing this forum: No registered users and 12 guests
The team
Delete all board cookies• All times are UTC - 5 hours Powered by phpBB© 2000, 2002, 2005, 2007 phpBB Group
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.