pre 64 model 70 receiver sight dummy screw size
Posted: Fri Oct 21, 2016 10:22 am
Hello everyone!
I'm a newby to the sight, but not a newby to Winchester collecting. I've mostly focused on leverguns and pump-actions in the past but I have recently picked up a Model 70 made in 1953 in .257 Roberts.
The rifle is missing one of the dummy screws that go in the factory drilled side-mounted receiver sight holes. I'm trying to order a replacement to fill the hole but I'm not sure what size screw is needed. I've looked at schematics online at Numrich but I have not been able to find anything. The top scope base holes appear to be 6-48 but these holes are smaller. Any help would be appreciated.
Thanks, Steve
I'm a newby to the sight, but not a newby to Winchester collecting. I've mostly focused on leverguns and pump-actions in the past but I have recently picked up a Model 70 made in 1953 in .257 Roberts.
The rifle is missing one of the dummy screws that go in the factory drilled side-mounted receiver sight holes. I'm trying to order a replacement to fill the hole but I'm not sure what size screw is needed. I've looked at schematics online at Numrich but I have not been able to find anything. The top scope base holes appear to be 6-48 but these holes are smaller. Any help would be appreciated.
Thanks, Steve