Hello everyone!
I'm a newby to the sight, but not a newby to Winchester collecting. I've mostly focused on leverguns and pump-actions in the past but I have recently picked up a Model 70 made in 1953 in .257 Roberts.
The rifle is missing one of the dummy screws that go in the factory drilled side-mounted receiver sight holes. I'm trying to order a replacement to fill the hole but I'm not sure what size screw is needed. I've looked at schematics online at Numrich but I have not been able to find anything. The top scope base holes appear to be 6-48 but these holes are smaller. Any help would be appreciated.
Thanks, Steve
pre 64 model 70 receiver sight dummy screw size
4 posts
• Page 1 of 1
Welcome to the Winchester Owners Forum Steve !!
Please introduce yourself to our community via the New Member Welcome Area... Enjoy the forum !! |
|
Call Brownell's, they can probably tell you what size as well as provide the filler screw you need. FWIW I looked at my pre-war M70 and they look like a size 6, but I did not remove one to check.
|
|
I have a few if you haven't found the replacements yet. Send me a PM with your address and I'll mail you 4 of them.
1957 Model 70 30.06
1958 Model 70 300 H&H Mag |
|
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests
Winchester Owners Forum is privately owned and operated. It is not affiliated or operated by Winchester company.
Views and opinions expressed here are not necessarily that of Winchester.